Welcome to the Crown Vics ETC blog!

On April 6, 2000, I purchased a 1998 Ford Crown Victoria LX HPP with 23,490 miles. I decided to start a little website for it featuring a running log of my experiences with the car. Vic 1.0 was retired in 2015 due to rust and electrical issues. Vic 2.0 was a 2006 P71 in Blue Pearl that belonged to my boyfriend. It was a Ford demo and never saw actual police use. It was damaged in September of 2018 with well over 186,000 miles. It was replaced by Vic 3.0 in October 2018, a 2008 P71 in Silver Birch with 120,971 miles. To read posts prior to 2010, click a link at right, or go to Crown Vics, ETC.

Friday, November 20, 2026

REPAIR: Inner Tie Rod End

We just replaced Vic 3.0's driver side inner tie rod end.  The day didn't go as planned, so we had to finish the job in the dark.  Most difficult part was the bleeping small clamp that holds the rubber boot.  Every pair of pliers we had were a smidge too narrow and MAN what a pain it caused.  The jam-nut needed to be heated. Otherwise things were straightforward.

Only worry I have is the alignment may be slightly off.  We counted the "spins" of the outer end but when I parked the car in the driveway, the front wheels looked a bit "off".  I'll know when I drive it more than one block... 

Last week we put two older but meatier RS-A's on the back, since my snow tires wore out before last winter.  Thankfully this made the tire pressure light go off, as one of my rims had a dead sensor.   

Vic also has a new inspection sticker.  So it is good for what may be its last year on the road.