Welcome to the Crown Vics ETC blog!

On April 6, 2000, I purchased a 1998 Ford Crown Victoria LX HPP with 23,490 miles. I decided to start a little website for it featuring a running log of my experiences with the car. Vic 1.0 was retired in 2015 due to rust and electrical issues. Vic 2.0 was a 2006 P71 in Blue Pearl that belonged to my boyfriend. It was a Ford demo and never saw actual police use. It was damaged in September of 2018 with well over 186,000 miles. It was replaced by Vic 3.0 in October 2018, a 2008 P71 in Silver Birch with 120,971 miles. To read posts prior to 2010, click a link at right, or go to Crown Vics, ETC.

Tuesday, July 27, 2021

Reattaching a Power Door Lock Actuator in Mom's 2011 Ford Crown Victoria

A while ago, my mother asked me what a certain noise was in her 2011 Crown Vic.  She also said the passenger door lock wasn't working.  It didn't take long for me to figure out the big rivet that holds the power door lock actuator to the door itself had broken off.  When that rivet breaks, the power lock won't function correctly as it needs to be firmly attached to the door to work.  This happened years ago to Vic 1.0, and my old mechanic used a nut & bolt to fix it.  

I decided I wanted to do the job right, so I sourced the correct rivets, and FINALLY forced myself to do the job recently on a hot summer day, borrowing a capable riveter and a few tools from Bob at Belmont Seat Cover.  

If you need to do this repair, some of the tools you'll need are a T25 torx, a 7mm socket, panel remover tool, patience.  The rivets I went with are Auto Body Master part number PM49930, purchased at Checkered Flag in Ayer MA.  There are others out there that will work, but I didn't need 100 of them!  Make sure they have a dome-like appearance like the originals.  

I didn't take photos when I started the project as I was just plain too distracted.  But taking the door panel off is a bit easier with this panel than the 1998 style ones, other than needing something other than a Phillips screw driver.  The most important thing to remember is, if someone hasn't already, DO NOT break the plastic tab off the switch panel!    This is very easy to do if you don't know about the problem.  Once you break it, the panel will never sit snug again without "persuasion".  And unless you have a black interior, finding a replacement will no longer be a simple task.  

Below are some "maps" to help you with this job.  Again, I didn't think to take pics until it was too late, but something's better than nothing!



Once you remove all hardware, simply lift the door panel up and off the door itself.  Feel around and you will find the lock actuator is just sort of hanging, thus banging around in the door, driving you nuts, and also making it so your power lock won't function correctly.  You will see the cad-plated bracket with a hole in it, perhaps even the remnant of broken rivet like in Mom's door.  You can clearly see the hole in the bracket, and how it should line up with the hole in the door.  I used some sticky black goo to help hold the two together while we prepped the riveter.  Then, POP went the rivet and the repair was all done!

Next, I taped up the black shield thingy and slipped the door panel back on... forgetting to line the lock knob up properly with the hole in the panel like I do every single time!!  Plug the switch panel back in, carefully pop it back on, and you're good to go.  


No comments:

Post a Comment